Re: Restore to a different LPAR without the EIM config

Thanks Jack. I'm going to try that on a test LPAR and see what, if any, problems it causes.

Thanks

Adam Driver
IBM Certified Systems Administrator - System i
Consultant - Infrastructure Engineer
Exacta Corporation
(608) 661 6697 ext 2581
adriver@xxxxxxxxxxxx<mailto:adriver@xxxxxxxxxxxx>
Please consider your environmental responsibility before printing this e-mail.

date: Fri, 12 Oct 2012 07:47:37 -0400
from: Jack Kingsley <iseriesflorida@xxxxxxxxx>
subject: Re: Restore to a different LPAR without the EIM config

You could omit them on your rst portion.

On Thu, Oct 11, 2012 at 4:48 PM, <ADriver@xxxxxxxxxxxx> wrote:

Hi,

Does anyone know of a way to restore a system to a different LPAR
WITHOUT restoring the EIM configuration?

The Info Center talks about the following objects for saving/restoring EIM:
QUSRDIRDB library
QUSRDIRCL library
QUSRSYS/QGLDCFG (*USRSPC object)
QUSRSYS/QGLDVLDL (*VLDL object)
/QIBM/UserData/OS400/DirSrv

Would it be just be as simple as omitting these on the restore? This
would be a scratch install too they wouldn't exist if not restored. Is
that likely to cause other issues?

- WEA Trust Confidentiality Notice -

This electronic mail message and any files transmitted with it are confidential and are intended solely for the use of the individual or entity to whom they are addressed. Dissemination, forwarding, printing, or copying of this electronic mail without the consent of the sender is strictly prohibited. If you are not the intended recipient or the person responsible for delivering the electronic mail to the intended recipient, be advised that you have received this electronic mail in error; please immediately notify the sender by return mail.