Re: CHGPF Ignore question

Hi Vern,

My problem isn't really the message -- my problem is that the command doesn't run, so the file doesn't get changed. In the past, I've been able to reply "ignore", and the command has gone ahead and changed the file, but now the second message just tells
me that data might be lost and the command is still sitting there on the command line.


Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx> writes:

Mike

I don't know the message - might be a diagnostic.

But there's a way to remove these from the log - it involves bracketing
your CHGPF command with a start message and an end message - your record
the message key for each, then loop through from the first to the last
and remove any you do not want, by some criteria. This link -
*http://tinyurl.com/7gec8lu - takes you to a page in a WDSC site - it's
taken from a KB article that I can't find right now.

HTH
Vern

Mike Naughton
Senior Programmer/Analyst
Judd Wire, Inc.
124 Turnpike Road
Turners Falls, MA 01376
413-676-3144
Internal: x 444
mnaughton@xxxxxxxxxxxx
****************************************
NOTICE: This e-mail and any files transmitted with it are confidential and solely for the use of the intended recipient. If you are not the intended recipient or the person responsible for delivering to the intended recipient, be advised that any use is
strictly prohibited. If you have received this e-mail in error, please notify us immediately by replying to it and then delete it from your computer.