Good day all
Before I do my usual thing and forget, we are on release V5r4
Why can't I add a primary key to a file in QTEMP?
I have the following script in a member called QSQLSRC(CR8VACOMP)
create table qtemp/vacomp as
(with vacatp as
(SELECT a.pcat FROM prodfa/pricep a, prodfa/nopickp b
a.psuffx = b.suffix and
a.pskuno = b.skuno
GROUP BY a.pcat
ORDER BY a.pcat)
select c.Lcmpy from prodfa/srcmstp c, vacatp d
where c.Lcatcd = d.Pcat
group by c.Lcmpy
order by c.Lcmpy)
The table is created no problem, however, for reasons TOO involved I need to make the one field LCMPY into the primary key
When I run the following command in STRSQL
ALTER TABLE QTEMP/VACOMP add primary key (LCMPY)
I get the following error
VACOMP in QTEMP not valid for operation.
Using F1 on this error, the following is displayed
Message . . . . : VACOMP in QTEMP not valid for operation.
Cause . . . . . : The reason code is 10. Reason codes are:
10 -- A constraint or trigger is being added to an invalid type of table,
or the maximum number of triggers has been reached, or all nodes of the
distributed table are not at the same release level.
The file is NOT journalled
However, when I change everything so that the file is created in another library, the add Primary key works
As always, all responses MUCH appreciated
That I run with the following command
Programmer/Analyst, Direct Response
"If you're going through Hell, keep going" - Winston Churchill
This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact