Hi Birgitta
It depends upon your definition of "heavily"
We use data areas quite a lot, for example, to hold a date when a program was last run, so that the next run of the same program will start from that date
Alan Shore
Programmer/Analyst, Direct Response
E:AShore@xxxxxxxx
P:(631) 200-5019
C:(631) 880-8640
"If you're going through Hell, keep going" - Winston Churchill
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Birgitta Hauser
Sent: Friday, May 13, 2011 11:17 AM
To: 'Midrange Systems Technical Discussion'
Subject: DataArea vs. Tables
Hi guys,
we just had a discussion about using data areas.
In my opinion they are not heavily used or needed.
I either create a table/physical file or store the information in global variables in a specific service program. The data within these global variables is set and retrieved by calling procedures.
I'm just curious, are you using data areas (heavily) or not?
Mit freundlichen Grüßen / Best regards
Birgitta Hauser
"Shoot for the moon, even if you miss, you'll land among the stars." (Les
Brown)
"If you think education is expensive, try ignorance." (Derek Bok)
"What is worse than training your staff and losing them? Not training them and keeping them!"
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a moment to review the archives at
http://archive.midrange.com/midrange-l.
midrange.com
