Re: Problems transferring with i Nav between V7R1 and V5R4

After upgrading to V7R1 of iNav, I unhappily report the same result. I can move objects from the V5R4 machine to the V7R1 machine, but not the other way. On the V5R4 machine I see a QHST log entry saying that the unpack failed because of incompatible SAVF release.

Reminds me of the way we could move data from the S/38 to the AS/400 but not vice versa when we were converting BPCS to the AS/400. Chuck Myaard said we would have to "wumpus up a way" to move the data, and we did - and the WRKWUMPUS command was born. :)

Joe

V5R4M0

Joe, what version of ISERIES Access.

On Wed, Jan 12, 2011 at 8:31 AM, Joe Pluta<joepluta@xxxxxxxxxxxxxxxxx>wrote:

We have a brand new V7R1 partition and I'm trying to send a library from
the V7R1 partition to the older V5R4 partition using iSeries Navigator
V5R4. It fails, and the message I get in the joblog is this:

CPF9812 Escape 40 01/12/11 06:57:11.456944
QSRLIBS1 QSYS *STMT QZRCSRVS QSYS *STMT
From user . . . . . . . . . :
JPLUTA
From module . . . . . . . . :
QSRS1MED
From procedure . . . . . . :
qsrSendMediaMessages
Statement . . . . . . . . . : 32
To module . . . . . . . . . :
QZRCRMTC
To procedure . . . . . . . :
RunCommand
Statement . . . . . . . . . : 49
Message . . . . : File @@5123 in
library QYDSOBJ0 not found.
Cause . . . . . : The file name
or the library name is not correct. If the
library name was not specified,
the file may be in a library that is not
contained in the library list.
Recovery . . . : Correct the file or
library name, or add the library
name to the library list. Then try the
request again.


The library being sent is @@5123. Not sure what QYDSOBJ0 is, probably a
temporary library. In QHST, I see a message that says a library cannot
be displayed or restored because it's the wrong level.

Cause . . . . . : The file was saved from a more recent release of the
operating system or the CD-ROM was not created correctly. The
operation was
requested for save file QYDS657270 in library QRPLOBJ.

I suspect that is the attempt to restore the save file that iNav sent over.

As a side point, when I manually create a save file and FTP it over, it
works fine. Any ideas?

Joe
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.