You need to run the command CRTLF against the new physical file in the new
library
Alan Shore
Programmer/Analyst, Direct Response
E:AShore@xxxxxxxx
P:(631) 200-5019
C:(631) 880-8640
"If you're going through Hell, keep going" - Winston Churchill
Pete Helgren
<pete@xxxxxxxxxx>
Sent by: To
midrange-l-bounce Midrange Systems Technical
s@xxxxxxxxxxxx Discussion
<midrange-l@xxxxxxxxxxxx>
cc
10/26/2010 12:51
PM Subject
Cannot Add a logical file member.
Not sure why
Please respond to
Midrange Systems
Technical
Discussion
<midrange-l@midra
nge.com>
I needed to set up a test environment so that I could run a program that
updates a file. The update is actually through a logical file (I didn't
write the program I just need to do some testing).
So I created a new library and used CRTDUPOBJ to create the Physical
File in the new library. Then I used CRTDUPOBJ to create the logical in
the same library even though the original logical didn't reside in the
same library as the physical at the time. I assumed (wrongly) that the
logical would find the physical in the target library and properly point
to it. It doesn't. The logical file still points to the physical file
in the production library.
So basically PF1 in Library A has a logical file LF1 in Library B and I
wanted to build a test library C where both PF1 and LF1 resided and had
the correct access path (pointing only to the file in library C).
So I deleted the logical that I created using CRTDUPOBJ and decided to
create the logical from source.
Here is the command I used: ===> CRTLF FILE(LibC/LF1)
SRCFILE(LibC/QDDSSRC) MBR(LF1) DTAMBRS((LibC/PF1 (PF1))) MAXMBRS(*NOMAX)
When I run it I get the following error:
File LF1 created in library LibC.
File PF1 in LibC on DTAMBRS not valid.
I don't know why. The LF should reside in library LibC and it should be
built over PF1. The source has the following:
R FPF1 PFILE(PF1)
A K PRKEY
A S SPID CMP(EQ 'SP')
A S PMETH CMP(EQ '1')
A S PTYPE CMP(EQ '4')
The PFILE specifies PF1 so I am not sure why the compile complains about
adding a DTAMBR. The created logical properly points to the physical
located in the same library when I view the access path setting in
DSPFD. So I am stumped. What am I missing? Using ADDLFM results in
the same error: File PF1 in LibC on DTAMBRS not valid.
--
Pete Helgren
Value Added Software, Inc
www.asaap.com
www.opensource4i.com
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at
http://archive.midrange.com/midrange-l.
midrange.com
