Re: STRPRTWTR and AUTOEND(*NO) will not stay started.

[Vern Hamberg <vhamberg@xxxxxxxxxxx>]

 Tom

Have you looked at the job log for the writer? WRKJOB wtrnam should get 
you there. Sometimes there are multiples behind the scenes - look at 
each one.

HTH
Vern

On 10/11/2010 12:23 PM, Tom Deskevich wrote:
> We have our STRPRTWTR default for AUTOEND changed to (*YES).
>
> But, when a certain customer requests a writer to be started, I want to change that to (*NO). So that the printer stays in RLS/WTR status.
>
> The writer will start, then about 30 seconds later, it will end.
>
> In my research I could not find anything that would cause this.
>
> Here is my CL command:
>
> STRPRTWTR  DEV(&PRTNAM) OUTQ(&OUTNAM) MSGQ(&ALNMSG) AUTOEND(*NO)
>
> The Printer, outq, and msgq come out of a menu system record.
>
> TIA
>
> Tom Deskevich
> INFOCON Corporation
> 814-472-6066
> Fax 472-5019