Re: STROBJCVN - Need to interrupt a V6R1M0 conversion -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

As far as I know, once converted, they don't need to be converted again. Unless you were to restore everything again!!

Hope that's right!
Vern

Paul Tormey wrote:

In my wisdom, I started the V6R1M0 STROBJCVN (*CONVERT) from my HMC Remote 5250 Console. Thoughts of having the system standalone while the conversion runs!

This was run just after I had done the upgrade from V5R4M0 using PWRDWNSYS using an image catalog. Off course that all completed okay. But I suspect, didn't check, that the system is still in restricted mode?

The pre upgrade ANZOBJCVN had been run and said the conversion would run for +/- 27 hours. The conversion started at 16:28 Sat 17/04/2010 and it's now 12:00 Sun 18/04/2010.

Further reading on the list and redbooks shows that one need not run in a 'stand alone' environment.

If I interrupt my HMC session and that ends the running STROBJCVN what are the implications?

1. Can I restart the conversion or would all that has been done be
backed out/rolled back?
2. I would IPL first so that the system is restarted in 'normal' mode.

Any ideas or recommendations would be appreciated.

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.