If you are brave you could try editing the QATMSMTPA file. Of course
you only need to add the SMTP aliases for the users who will actually
need to use the SNDDST command. Usually that's not too many.
Regards,
Scott Ingvaldson
Senior IBM Support Specialist
Midwest Region Data Center
Fiserv.
-----Original Message-----
From: Michael Smith [mailto:msmith@xxxxxxxxxxxxxx]
Sent: Wednesday, August 26, 2009 1:03 PM
To: Midrange Systems Technical Discussion
Subject: RE: [Junk released by Allow List] Re: SMTP Question
Scott,
That worked... but that means that I have to added an SMTP address for
every directory entry... Is that assumption correct?
Michael
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Scott Klement
Sent: Wednesday, August 26, 2009 1:44 PM
To: Midrange Systems Technical Discussion
Subject: [Junk released by Allow List] Re: SMTP Question
Type WRKDIRE
Place a 2(=Change) next to your profile
Press F19(=Change name for SMTP)
Michael Smith wrote:
When sending an email via the SNDDST command... the message is
delivered
properly, however the "from" name is as follows:
MSMITH@xxxxxxxxxxxxxxxxxxx
--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list To post a message email: MIDRANGE-L@xxxxxxxxxxxx To subscribe,
unsubscribe, or change list options,
visit:
http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx Before posting, please take a
moment to review the archives at
http://archive.midrange.com/midrange-l.
midrange.com
