It's hard to guess. Also you don't say where within the call stack you are
sitting (in relation to the generator of the messages), so guesses have even
less value.

If this is an interactive job, then get to the joblog and press F1 on the
"offending" messages, then F9 for details, and the From/To call stack
should, I believe, be identifiable there.

If it's a batch job, the printed job log should show the From and To message
queues. The TO message queue will, of course, be the value you use in your
RCVMSG PGMQ message.

HTH

Dennis Lovelady
http://www.linkedin.com/in/dennislovelady
--
"Few things are harder to put up with than the annoyance of a good example."
-- Mark Twain


Tried that. Did not work.

On Tue, Aug 18, 2009 at 3:09 PM, Wayne McAlpine <
wayne.mcalpine@xxxxxxxxxxxxxxxxx> wrote:

Alan, I believe you want PGMQ(*SAME). The message is not going to
the
*EXT queue.

Alan Campin wrote:
I have a message that is sent each time that a JDBC connection is
made.


This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].