×
The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.
We have a 5704 fiber card. Currently the fiber goes to an IBM 2109-F16
SAN switch. From there to a tape drive.
Is it possible for one 5704 card to have two tape drives in the same zone,
and to back up to them at the same time?
For example
ZONE1
LPAR_1_5704_1
TAPMLB01
TAPMLB02
and have a SAV going to one and a SAVLIB going to the other at the same
time?
Now, if that is possible, is this possible:
ZONE1
LPAR_1_5704_1
TAPMLB01
TAPMLB02
ZONE2
LPAR_2_5704_1
TAPMLB02
and if LPAR1 is done with it's save can LPAR2 now do it's save? Or can I
not have one device (TAPMLB02) in two zones?
We routinely do this
ZONEA
LPAR_1_5704_1
LPAR_2_5704_1
TAPMLB01
and when lpar 1 is done then lpar 2 can have it's way with it. Both
lpar's have their own 5704 card. No vary off/on needed. Just leave them
varied on.
Rob Berendt
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact
[javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
