When you are in the CHGTCPHTE command (option 10 then 2), you will see
bellow the host name: "+ for more values _" that is where you must put
the "+" to add another host name.

Denis Robitaille
Directeur services technique TI
819 363 6130

SUPPORT
Jour (EST) Daytime : 819-363-6134
En-dehors des heures (EST) After hour : 819-363-6158
Network Status : 819-363-6157

"Burns, Bryan" <Bryan_Burns@xxxxxxxxxxxx> 2008-09-09 09:50 >>>
+ is not an option. Or do I need to end TCP/IP for it to show so I can
add the name?

Bryan
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx]On Behalf Of Craig Jacobsen
Sent: Tuesday, September 09, 2008 8:31 AM
To: 'Midrange Systems Technical Discussion'
Subject: RE: How to Add Another Host Name

+ for more values (limit of 4 per IP).

HTH,

Craig

-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Burns, Bryan
Sent: Tuesday, September 09, 2008 9:22 AM
To: MIDRANGE-L@xxxxxxxxxxxx
Subject: How to Add Another Host Name

How do you add an additional host name to an existing host table entry?
I
see that some table entries have as many as four host names and I need
to
add a name to a host but the change option doesn't work. I'm using
CFGTCP
option 10 and then 2 for change.

Bryan Burns
iSeries Specialist
ECHO, Incorporated
Lake Zurich, Illinois

--


This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2020 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].