The problem is that I do not see any place to indicate SSL for my connection properties.
The Help contents indicate that there is a component IKEYMAN that is used to install the CA certificate into iSeries Access key database, but I do not see that either.
From what I recall in the past, there was an SSL component it iSeries Access that needed to be installed, but I do not see it in the selective setup window.
Thanks,
Jeff Young
Sr. Programmer Analyst
IBM -e(logo) server Certified Systems Exper - iSeries Technical Solutions V5R2
IBM Certified Specialist- e(logo) server i5Series Technical Solutions Designer V5R3
IBM Certified Specialist- e(logo)server i5Series Technical Solutions Implementer V5R3
----- Original Message ----
From: Paul Nelson <nelsonp@xxxxxxxxxxxxx>
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Sent: Thursday, January 10, 2008 3:30:01 PM
Subject: RE: Configure INav to use SSL
You need to get the certificate from that system's administrator and import
it into your PC.
Then, in the configuration of your CA session, you click the properties of
the server, and define you are using SSL and where to get the certificate.
Paul Nelson
Cell 708-670-6978
Office 512-392-2577
nelsonp@xxxxxxxxxxxxx
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jeff Young
Sent: Thursday, January 10, 2008 2:25 PM
To: Midrange Systems Technical Discussion
Subject: Re: Configure INav to use SSL
I am connecting to a remote System i that uses SSL.
I need to configure iSeries Access to get the certificate and use SSL for
connections.
Thanks,
Jeff Young
Sr. Programmer Analyst
IBM -e(logo) server Certified Systems Exper - iSeries Technical Solutions
V5R2
IBM Certified Specialist- e(logo) server i5Series Technical Solutions
Designer V5R3
IBM Certified Specialist- e(logo)server i5Series Technical Solutions
Implementer V5R3
----- Original Message ----
From: Paul Nelson <nelsonp@xxxxxxxxxxxxx>
To: Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
Sent: Thursday, January 10, 2008 3:14:32 PM
Subject: RE: Configure INav to use SSL
Have you created the necessary certificate(s)?
You need to begin with configuring DCM through
http://yoursystem:2001 after
you start the ADMIN instance in your HTTP server
STRTCPSVR *HTTP HTTPSVR(*ADMIN)
Paul Nelson
Cell 708-670-6978
Office 512-392-2577
nelsonp@xxxxxxxxxxxxx
-----Original Message-----
From: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Jeff Young
Sent: Thursday, January 10, 2008 1:59 PM
To: midrange-l@xxxxxxxxxxxx
Subject: Configure INav to use SSL
Where do I find the component to allow iNav to configure an SSL connection
to a remote system?
I am running iSeries Access V5R3M0 and do not see an SSL component in the
Selective Setup install window.
Thanks,
Jeff Young
Sr. Programmer Analyst
IBM -e(logo) server Certified Systems Exper - iSeries Technical Solutions
V5R2
IBM Certified Specialist- e(logo) server i5Series Technical Solutions
Designer V5R3
IBM Certified Specialist- e(logo)server i5Series Technical Solutions
Implementer V5R3
midrange.com
