Tommy,
No, just one spooled file 74 pages. I wish that it was something like that.
Thanks,
Fran
<Tommy.Holden@xxxxxxxxxxxxxxxxxxxxx> 01/02/2008 12:37 PM >>>
did you run that over all of the spooled files in the OUTQ??? if so that's
the problem....
Print sequence (PRTSEQ) - Help
cause the position of the file on the output queue to
change.
*NEXT
The attributes of the file (or files) are changed so
that they are moved to the top of the output queue.
If PRTSEQ(*NEXT) is specified when the SELECT
parameter is specified, files with selection values
are moved ahead of the files that do not meet the
requirements. Two files that are both moved may
the system is juggling all the spooled files to place them all to be
printed first in the outq...
Thanks,
Tommy Holden
"Frances Denoncourt" <Frances.Denoncourt@xxxxxxxxxxxxxx>
Sent by: midrange-l-bounces@xxxxxxxxxxxx
01/02/2008 01:32 PM
Please respond to
Midrange Systems Technical Discussion <midrange-l@xxxxxxxxxxxx>
To
<midrange-l@xxxxxxxxxxxx>
cc
Subject
RE: PRTSEQ(*next) causes Necessary Resource not Available
Maybe I posted this too close to the holidays, but I was hoping someone
had an idea what was happening.
This is the original post. We are at V5R2M0
Thanks.
I think this entry caused a problem with an outq or controller or
something.
WRKOUTQ TRSPRT23 to display spooled files.
Took option 2 to change and entered this sequence:
outq(trsprt04) save(*yes) prtseq(*next)
I have not had a problem with this before, but it caused my session to
lock up - killed it after 20 minutes or so and went home. I did not end
the job properly knowing I was going home and the signon would be
available the next day after it got over it. That was Friday night.
An overnight job that had several OVRPRTF to TRSPRT04 failed because it
could not allocate the queue.
I thought it was 'fixed' this morning and used the exact same sequence
again and locked up the works again. This time I ended the job properly
and we seem to be in business - except for the job that blew up and should
have posted tons of stuff.
Any ideas about that command sequence??
Thanks
Fran Denoncourt
Sr. Programmer/Analyst
Pinal County Treasurer's Office
Florence, AZ 85232
(520) 866-6404
Receipt of this message does not grant you permission to send me
Unsolicited Commercial Email
midrange.com
