× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.



Matt Gross wrote:
As a follow-up to the IPL halt, I wanted to check that the console was set to
address 0. It is definitely at Port 0 on the "Brick".

I held down the space bar and turned on the display. In the far-right
lower corner, there are two dashes "--". I'm pretty sure this is where the
address should display.

Does anyone know how I can set the address - I haven't done this in a long
time. Each time I would press a key, "9013" would appear and I'd have to use
the reset key.

TIA,

Matt

After powering on with the space bar depressed,
Try F23 to cycle thru the addresses (0-7) for the 1st session.

F24 sets the second session's address
F20 should set the second session type (display or printer)

As an Amazon Associate we earn from qualifying purchases.

This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.