|
from: "Glenn Gundermann" <ggundermann@xxxxxx>
I have a barcode and it just fits on the label with no room to spare.
I
was thinking of shrinking it a touch to give it some more room. I have changed the BY instruction and it had no affect. I would appreciate
some
comments from those more experienced.
With the code below, I changed the ^BY from 2,3 to 2,2 and there was no change with the label.
The zpl manual (free from Zebra's website if you don't already have it. Or it might be the user's guide...its been a while.) goes into this issue, and long story short, it's a matter of floating point ratio calculations vs fixed dot sizes. Not all combinations of width/ratio are possible depending on what print head is installed in the printer and how much data you are encoding. Like I said though, the ZPL manual goes into it, and even provides the equations/charts/etc to figure out how (or if possible) to get the ratio/size you want.
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.
midrange.com
