RE: SED on AS400

["Winchester Terry" <terry.winchester@xxxxxxxxxxxxxxx>]

Here's the GURU newsletter link:

http://www.itjungle.com/fhg/fhg100406-story02.html

Terry Winchester 
Programmer/Analyst
________________________________
The Raymond Corporation
terry.winchester@xxxxxxxxxxxxxxx 

> -----Original Message-----
> From: midrange-l-bounces@xxxxxxxxxxxx 
> [mailto:midrange-l-bounces@xxxxxxxxxxxx] On Behalf Of Michael Ryan
> Sent: Wednesday, October 04, 2006 9:52 AM
> To: Midrange Systems Technical Discussion
> Subject: Re: SED on AS400
>
> That was just in 400 Guru (or whatever it's called) today. 
> Geez...I deleted
> the link to it.
>
> On 10/4/06, fbocch2595@xxxxxxx <fbocch2595@xxxxxxx> wrote:
> > Does anyone have experience in working with the SED pgm in 
> qshell?  If
> > possible, does anyone have any syntax of how it could be 
> used on an AS400
> > command line?
> >
> > We have a lot of stmf's from business partners that contain 
> blanks and
> > instead of writing pgm's to remove the blank lines we'd 
> like to use the SED
> > pgm, if possible.
> >
> > Thanks for any info

Confidentiality Notice:

The preceding e-mail message (including any attachments) contains information 
that may be confidential, protected by applicable legal privileges, or 
constitute non-public information. It is intended to be conveyed only to the 
designated recipient(s). If you are not an intended recipient of this message, 
please notify the sender by replying to this message and then delete it from 
your system. Use, dissemination, distribution or reproduction of this message 
by unintended recipients is 
not authorized and may be unlawful.