RE: Reset SPCN Sequence

You've gotta put it in manual before it goes ta 33...

Regards,
 
Scott Ingvaldson
iSeries System Administrator
GuideOne Insurance Group


-----Original Message-----
date: Fri, 22 Sep 2006 13:31:56 -0500
from: "Haase, Justin C." <justin.haase@xxxxxxxxxxxx>
subject: Reset SPCN Sequence

Folks,

Got an old 720 here of which I replaced a backplane in the 5065 because
the fiber transmitter went flaky.  Anyway - now that it's on the system,
the SPCN sequence reported on the operator panel of the 5065 is *09 when
it should be *02.  I am pretty sure that a function 33 from the control
panel should resequence SPCN, but I can't figure out how to get it to
that high of a number.

Anyone have the easy way to do this?  I'm pretty confident I need to be
in a manual-mode IPL to the DST menu, and then I should be able to do it
- I haven't done this in ages, do I then need to do the 25/26 to enable
extended functions - arrrgh!  Help!  Thanks.

Justin C. Haase - iSeries System Engineer
IBM Certified Systems Expert - System i
Kingland Systems Corporation