BRMS Status Messages

Morning folks,

Using BRMS for the first time in about 6 years - a little rusty.  Doing
the strbkubrm ctlgrp(*system) sbmjob(*no) command to get a base save on
multiple systems - it's working, everything appears good, but I don't
get status messages on libs saved.  I do start getting counts in the
message area when it hits the IFS.

Is there a way to make it show me what library it's currently processing
like a GO SAVE 21 will?  Apologize in advance if this is real simple.


--
Justin C. Haase - iSeries System Engineer
IBM Certified Systems Expert - System i
Kingland Systems Corporation


CONFIDENTIALITY NOTICE: This e-mail communication, including attachments, is 
covered by the Electronic Communications Privacy Act, 18 U.S.C. 2510-2521, is 
confidential, and may be legally privileged. If you are not the intended 
recipient or believe you received this communication in error, please reply to 
the sender indicating that fact and delete the copy you received. In addition, 
retention, dissemination, distribution, copying, or otherwise use of the 
information contained in this communication is strictly prohibited. Thank you.