RE: Change Console Mode

["Eduard van den Braken" <Eduard.van.den.Braken@xxxxxxxxxxxxxx>]

I think you have to change that using DST
In V5R2 the value is telling the maximum level of Console that is used.
In V5R3 the value is telling the exact level of the Console that is used

The instruction in V5R3 is

During install of LIC:

If the console mode value is zero, the Accept Console display appears.
If this display appears, follow these steps: 
Press F10 to accept the current console type. The Accept and Set New
Console Type on this IPL display appears. The old value (zero) and the
new value to be set (your current console type) is shown. 
Press Enter to set the new value and continue with these instructions.

If the Accept Console display in the above step did not appear, set the
console mode for this partition: 
At the IPL or Install the system display, select option 3 to access
Dedicated Service Tools (DST). 
Sign on as security officer (QSECOFR user profile / QSECOFR password).
When prompted, change the password to what you want to use for this
partition. 
Select option 5 (Work with DST environment). 
Select option 2 (System devices). 
Select option 6 (Console mode). 
Select the valid console that you have for this partition. Press Enter
and then press F3 to return to the DST main menu. 
Note:
If you are using Operations Console (LAN) as your console type, press
Enter on the verify window. You can also press F11 to review your
network configuration.




===================================================
Met vriendelijke groet,
Inter Access BV

Eduard van den Braken
Technisch Consultant iSeries

===================================================
The information contained in this message may be confidential and 
is intended to be exclusively for the addressee. Should you receive 
this message unintentionally, please do not use the contents herein 
and notify the sender immediately by return e-mail.

-----Oorspronkelijk bericht-----
Van: midrange-l-bounces@xxxxxxxxxxxx
[mailto:midrange-l-bounces@xxxxxxxxxxxx] Namens MWalter@xxxxxxxxxxxxxxx
Verzonden: woensdag 19 januari 2005 16:14
Aan: Midrange Systems Technical Discussion
Onderwerp: Change Console Mode

Is it possible to change the Console Mode from Twinax to Operations
Console
for an existing installation. iSeries is an 810 running V5R2.

Thanks,

Mark

Mark D. Walter
Senior Programmer/Analyst
CCX, Inc.
mwalter@xxxxxxxxxx
http://www.ccxinc.com

-- 
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.