Re: 270 Power supply

if you are going to have an electrician test the circuit - have him test
also while
laser is powered on and then test when it's been idle & receives a print
job.
Depends on laser and your circuit load.
jim
----- Original Message ----- 
From: "Art Tostaine, Jr." <atostaine@xxxxxxxxx>
To: "Midrange Systems Technical Discussion" <midrange-l@xxxxxxxxxxxx>
Sent: Monday, December 20, 2004 2:03 PM
Subject: Re: 270 Power supply


> I have that UPS they used to sell with the 270's.  Powerware 9910-15.
> The only other thing I have on there is my house alarm.  Nothing
> serious.
>
> The Laser printer might be on the same circuit though.  Could that be a
problem.
>
> Art
>
>
> On Mon, 20 Dec 2004 11:58:43 -0500, Jim Franz <franz400@xxxxxxxxxxxx>
wrote:
> > Is the UPS both a surge & sag protector? Many older UPS's don't protect
> > if power sags but does not fail. Also, hopefully you do not have a laser
> > printer in the same UPS. Lasers and the way they cycle & warm up will
> > kill many UPS's and if not a great UPS, whatever is attached.
> > I work from a home office and found certain appliances cause a sag, and
> > have had to get a good UPS to handle it.
> > jim
> -- 
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>
>