RE: Tape unload command

["Dennis Nel" <dennisn@xxxxxxxxxx>]

CHKTAP DEV(TAP01)     
       ENDOPT(*UNLOAD)

Regards,
Dennis Nel
Production Support Manager
ABSA Corporate & Merchant Bank

* dennisn@xxxxxxxxxx   
* +27 (0)11 350-8109
* +27 (0)11 350-8379
* +27 (0)82 491-6892
161 Main Street, Johannesburg, 2001
Po Box 2683, Johannesburg, 2000

-----Original Message-----
From: midrange-l-bounces+dennisn=absa.co.za@xxxxxxxxxxxx
[mailto:midrange-l-bounces+dennisn=absa.co.za@xxxxxxxxxxxx] On Behalf Of
Ritsema, Doug B
Sent: 18 November 2004 4:45 PM
To: 'midrange-l@xxxxxxxxxxxx'
Subject: Tape unload command

Is there a command that will just unload a tape?  I've used DSPTAP
ENDOPT(*UNLOAD) but I was wondering if there was a faster way to do it.

TIA

Doug Ritsema
Holland American Wafer Co.

--
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
To post a message email: MIDRANGE-L@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/midrange-l
or email: MIDRANGE-L-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.


___________________________________________________________

Important Notice: 
Authorised Financial Services Provider

Important restrictions, qualifications and disclaimers 
("the Disclaimer") apply to this email. To read this click on the 
following address or copy into your Internet browser: 

http://www.absa.co.za/ABSA/EMail_Disclaimer

The Disclaimer forms part of the content of this email in terms of 
section 11 of the Electronic Communications and Transactions 
Act, 25 of 2002. 

If you are unable to access the Disclaimer, send a blank e-mail 
to disclaimer@xxxxxxxxxx and we will send you a copy of the 
Disclaimer.