Overlay Error

["Tim Randall" <TRandall@xxxxxxxxxxx>]

Hello I have been using an overlay for a print job for a long time.  I had to 
make a change to the overlay and I have come across a problem.  I use WordXP to 
create the *.prn file and then save it to QDLS.  I then use the CPYFRMPCD 
command to covert it to a PF and then use the CRTOVL command to create the 
overlay.  I get the following error message:                          
Additional Message Information                                                  
                                                        Message ID . . . . . . 
:   CPD88C0                                              Date sent  . . . . . . 
:   07/19/04      Time sent  . . . . . . :   11:01:11                           
                                                         Message . . . . :   
File OVERLAYS in TIMLIB not valid for creating a *OVL.                          
                                                            Cause . . . . . :   
The file or member cannot be used to create a printer         resource. *N 
means that the incoming data was an internal system space. No      source file 
or library is specified. The reason code is 02.  The reason         codes and 
their meanings are:                                                     1 - A 
length field contained in the incoming data for the printer resource    is not 
correct.                                                                   2 - 
The structured field identifier in the incoming data for the printer      
resource is not correct or is not supported. The error was detected while       
processing record 1, byte number 17. The structured field which is not          
correct may be caused by a length that is not correct on the previous           
structure field. The structured field which was being processed at the time     
is '5A0010D3A8C6'X.                                                             
  3 - The file or member specified contains no data.                            
  4 - The incoming data for the printer resource is not correct. The            
resource must contain an END structured field that is appropriate for the       
type of resource being created.  The END structured field identifier            
expected for this resource is ''X.                                            
Recovery  . . . :   Verify that the names of the file, library, and member are  
  specified correctly on the command.  If the data originated on another        
  system, also make sure that the record length of the physical file is         
  correct.                                                                      
                                                                                
Has anyone else run into this problem and/or know what is causing the problem? 
Thanks,Tim Randall
Programmer/Analyst
City of Independence