Re: Drawing Boxes in a prtf using HPT

["Jim Franz" <franz400@xxxxxxxxxxxx>]

Pat - you had told me this was :Remote site with 3488's and Lexmark Optra R
attached to
3488... I have it configured as 5219 using HPT=Yes..

you changed the printer config to 3812 - did you change the 3488's
definition for the printer port.?
I don't have book or terminal to test. Is their a selection of printer type
in terminal definition of printer port?
jim


----- Original Message -----
From: "Pat Barber" <mboceanside@xxxxxxxxxxxxxxxx>
To: "Midrange Systems Technical Discussion" <midrange-l@xxxxxxxxxxxx>
Sent: Tuesday, August 12, 2003 4:25 PM
Subject: Re: Drawing Boxes in a prtf using HPT


> Changed the printer to 3812 and that did allow the program
> to run ok... It puts the print file out just fine. When I
> attempt to print the file, it "appears" to come to the printer
> and the printer cycles like it going to print, but nothing
> actually prints... Any ideas ???
> _______________________________________________
> This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing
list
> To post a message email: MIDRANGE-L@xxxxxxxxxxxx
> To subscribe, unsubscribe, or change list options,
> visit: http://lists.midrange.com/mailman/listinfo/midrange-l
> or email: MIDRANGE-L-request@xxxxxxxxxxxx
> Before posting, please take a moment to review the archives
> at http://archive.midrange.com/midrange-l.
>
>