Re: RTVCMDSRC (CHGCMDDFT, how can I see all?)

["Al Barsa" <barsa@xxxxxxxxxxxxxxxxxxx>]

I don't remember exactly, but it generally has to do with the SPCVAL
parameter.

Al

Al Barsa, Jr.
Barsa Consulting Group, LLC

400>390

914-251-1234
914-251-9406 fax

http://www.barsaconsulting.com
http://www.taatool.com






                      "Carsten
                      Flensburg"                To:       
<midrange-l@midrange.com>
                      <flensburg@novasol        cc:
                      .dk>                      Subject:  Re: RTVCMDSRC 
(CHGCMDDFT, how can I see all?)
                      Sent by:
                      midrange-l-admin@m
                      idrange.com


                      12/31/2002 11:17
                      AM
                      Please respond to
                      midrange-l






Hello Al,

- Do you have any specifics about what is causing the prompts to fail; is
it
the same problem every time or many different?

Best regards,
Carsten Flensburg

----- Original Message -----
From: "Al Barsa" <barsa@barsaconsulting.com>
To: <midrange-l@midrange.com>
Sent: Tuesday, December 31, 2002 4:57 PM
Subject: Re: RTVCMDSRC (CHGCMDDFT, how can I see all?)


>
> I've used this command, and it does a good, but not perfect job.  On each
> release, I retrieve all of the commands on the system, and then run the
> source through my own code that essentially runs them through the
prompter
> in batch.  99% prompt properly, but there is that less than 1% that
fails.

_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
or email: MIDRANGE-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.