RE: CAE V4R5 SSL 992 question

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

What type of router are you using?  How are you closing port 23?  We have
CISCO routers.  You have to NAT each port you want open.  Don't forget about
the Server Mapper at 449.

Christopher K. Bipes      mailto:ChrisB@Cross-Check.com
Operations & Network Mgr  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.                  http://www.cross-check.com
6119 State Farm Drive     Phone: 707 586-0551 x 1102
Rohnert Park CA  94928    Fax: 707 586-1884

-----Original Message-----
From: Mark Villa [mailto:markvilla@knology.net]
Sent: Friday, November 09, 2001 8:57 AM
To: midrange-l@midrange.com
Subject: CAE V4R5 SSL 992 question


Any suggestions?
================
We can connect to all secure ports just fine.

The router is the typical internet connection and is nat'ed to the 400.
AS400 IP Packet security is default and not active.

All router ports are open.

If we close the router port 23, that causes the next SSL connect attempt
from the internet side to time out.

Tried using STANDARD mapping in Client Access.

When we open Port 23 back up, We can connect on 992.

I think we have the PTF's and service packs needed.
===================================================

Stumped?


Mark Villa in Charleston SC


_______________________________________________
This is the Midrange Systems Technical Discussion (MIDRANGE-L) mailing list
To post a message email: MIDRANGE-L@midrange.com
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/cgi-bin/listinfo/midrange-l
or email: MIDRANGE-L-request@midrange.com
Before posting, please take a moment to review the archives
at http://archive.midrange.com/midrange-l.