|
>This sounds like PTFs may be missing, and you're right; the message isn't >too helpful. End the writer, vary the device off, power the printer off, >wait 30 seconds. Power the printer on, vary the device on, start the writer >and see if it gets better. This will reset the hardware and the software. This doesn't make any difference for us either, our spool file doesn't go to a save status either. Thanks Dan **off-topic** but on a different note and may be fun... A solar explosion on Tuesday (Oct. 9th at 1110 UT) hurled a full-halo coronal mass ejection toward Earth. The expanding cloud, which sped away from the Sun traveling approximately 1000 km/s, could strike our planet's magnetosphere as soon as Thursday, Oct. 11th. Sky watchers, especially those living above geomagnetic latitude 50 degrees, should remain alert for Northern Lights during the nights ahead. The best time to spot auroras is usually around local midnight. http://www.spaceweather.com
As an Amazon Associate we earn from qualifying purchases.
This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].
Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.