RE: CLRLIB QRPLOBJ?? (was Re: IPL regains storage.......but)

I've had to do some investigation.
I was wrong in my previous post.
The bottom line is PTF process moves data to QRPLOBJ only if it is not
supposed to be used anywhere on system.
So as far as system itself is concerned it is safe to clear QRPLOBJ
anytime.

    Alexei Pytel

"The better is the worst enemy of the good"


----- Forwarded by Alexei Pytel/Rochester/IBM on 08/27/2001 11:53 AM -----

                    Alexei Pytel
                                         To:     midrange-l@midrange.com
                    08/25/2001           cc:
                    06:26 PM             From:   Alexei 
Pytel/Rochester/IBM@IBMUS
                                         Subject:     RE: CLRLIB QRPLOBJ?? (was 
Re: IPL
                                         regains storage.......but)(Document 
link: Alexei
                                         Pytel)









When PTF is applied - say a program object is replaced - the old object is
moved to QRPLOBJ.
In this way jobs which were using old program will continue to use it.
Deleting a program when some job is executing instructions from this
program, will cause the job to fail.
This is why PTF process uses QRPLOBJ.
It is safe to clear QRPLOBJ at IPL time, because there are no jobs using
any object from QRPLOBJ.

Earlier in this thread Tom Liotta said that you should be careful what you
remove from QRPLOBJ - very true.

Best regards
    Alexei Pytel

"The better is the worst enemy of the good"