Re: PTF apply problem

[D.BALE@xxxxxxxxxxxxx]

I think it's time to call IBM.  Oh, wait, are you with IBM?  I'm guessing from
your email address (mihai_badea@ro.ibm.com) that you might be with IBM in ...
Romania???

Anyway, here in the U.S., the situation you describe would be an immediate
call to the IBM Support Line.  Is there any mention of the particular
situation in the special instructions for that cume PTF?

Good luck!

Dan Bale
IT - AS/400
Handleman Company
248-362-4400  Ext. 4952
D.Bale@Handleman.com
  Quiquid latine dictum sit altum viditur.
  (Whatever is said in Latin seems profound.)

-------------------------- Original Message --------------------------

Hi everyone.

I have a problem with applying a cumm PTF on V4R3M0.
I have detected a problem in a LIC module so I restored on the system only
the LIC and OS/400 from the installation CDs.
After the restore I tried to apply the last cumm package for V4R3 -
C0280430. The PTFs were loaded OK but the applying of PTFs failed. In the
log I found some OS/400 PTFs that were not applied. The reason was  that
some prerequisite LIC PTFs were not applied permanently.
When I looked to the LIC PTFs indicated by the system, the PTFs were
PERMANENTLY APPLIED. I tried to apply the OS/400 PTFs manually (APYPTF ...)
but the result was the same.

Does anyone know what should be done in this situation to apply the
previously mentioned PTFs.
I'll appreciate any input.
Thank you.

Best regards,
Mihai Badea.
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---