ODP: S36 on an AS/400

[krzysztof.zygulski@xxxxxx]

Hi,
I am not sure if here is a clue but...:
In the user profile there is a special environment parameter, if it is set
to *S36 you are running S36 emulation. You can start the s36 session
emulation from command line 'strs36'. If you are in S36 environment you can
see it i.e. from the terminal names. They have 2 characters only. 

Regards

Krzysztof

-----Oryginalna wiadomo¶æ-----
Od: James W. Kilgore [mailto:eMail@James-W-Kilgore.com]
Wys³ano: 18 kwietnia 2001 08:52
Do: MIDRANGE-L@midrange.com
Temat: Re: S36 on an AS/400


Jerome,

If one is running a S/36EE, when you type commands at a command line
they will always be in upper case (native is lower case).  I don't know
about a *M36, never seen one.

Jerome Draper wrote:
> 
> How does one tell if you are running in S36 emulation? mode or machine 36?
> mode on an AS400?
>
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---