Re: Language changed during an upgrade

[barsa@xxxxxxxxxxxxxxxxxxx]

Mike,

You have two problems.  What did IBM do to you, and how to fix it.  I have
the following suggestions:

1.)  You have to call IBM, an d figure out what happened to your records.
2).  You need to play a strategy to get back to 2924 as a primary language.
The Software Installation guide describes how to do this, although I have
never done it.

Al



Al Barsa, Jr.
Barsa Consulting Group, LLC

400>390

914-251-1234
914-251-9406 fax

http://www.barsaconsulting.com
http://www.taatool.com





                                                                                
                                         
                    Michael.Franchino@c                                         
                                         
                    ussys.com                  To:     MIDRANGE-L@midrange.com  
                                         
                    Sent by:                   cc:                              
                                         
                    owner-midrange-l@mi        Subject:     Language changed 
during an upgrade                           
                    drange.com                                                  
                                         
                                                                                
                                         
                                                                                
                                         
                    04/09/01 10:33 PM                                           
                                         
                    Please respond to                                           
                                         
                    MIDRANGE-L                                                  
                                         
                                                                                
                                         
                                                                                
                                         





Anyone,

We just installed V4R5 on our development 170. I don't know what the
primary language was but I am guessing 2924. Well, after the upgrade we now
have 2938 installed as the primary and 2924 as the secondary. We are unsure
how IBM or why IBM shipped us DB enabled english, but we now have it on our
machine. The problem is, all of the menus are uppercase not lower.. I
changed the QLANGID system value from ENP to ENU. I don't know if that will
do anything, I haven't IPLd.

Any ideas? Is there anyway to go back to plain ole 2924??? Without
restoring our backup that is.

Michael Franchino
Custom Systems Corporation
(973) 383-7808 X214 (Phone)
(973) 383-6398 (Fax)

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---






+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---