• Subject: DUPTAP problem
  • From: RampaL@xxxxxxxxx
  • Date: Tue, 21 Nov 2000 09:19:36 +0100

Hello,
discovered this yesterday:
I need to copy two 8mm (2GB) tapes to 5.25inch tape (4GB).
Source tape 1 contains partial file at the end, this file
continues on source tape 2.

When duplicating tapes, program QTAERR sends msg CPA4088 asking
for source tape change, but I have no chance to answer the message,
because "somone" answers it with Cancel reply. DUPTAP then ends.

There is no such entry in System reply list.

Source drive is 7208-342 (20GB 8mm), dest. drive is 6382
(4GB 5.25inch).

I've tried also to copy 8mm tape to more small 5.25inch tapes,
as in the first case there was CPA4088 (asking me to insert next
destination tape) and again there was Cancel reply.

I'm on V4R4.

Can anybody help?

Thanks

Lukas Rampa
----------------------------------------------------------------------
Aimtec a.s.                                        Tel.: +420197225215
http://www.aimtec.cz                                Fax: +420197221732
Halkova 32                                       Lukas.Rampa@aimtec.cz
301 22 Plzen                                            Czech Republic

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---

This thread ...


Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].