Re: client access connection

Sometime this is caused by an invalid user profile.  It could be an invalid
parameter or if the system was upgraded from CISC
version and the password for the profile had not been changed from the CISC
version(pre v3r1 if I remember right).

Try this CHGUSRPRF   username then press F-4.  Retype the first letter of
the jobd parameter.  If is incorrect
you will get a message on the chgusrprf command.  If that is not it check
the OUTQ parm.



Bryan Dietz




                                                                                
                     
                    "Carley, Neil"                                              
                     
                    <carleyn1@midas-kap        To:     
"'MIDRANGE-L@midrange.com'"                   
                    iti.com>                   <MIDRANGE-L@midrange.com>        
                     
                    Sent by:                   cc:                              
                     
                    owner-midrange-l@mi        Subject:     client access 
connection                 
                    drange.com                                                  
                     
                                                                                
                     
                                                                                
                     
                    11/01/2000 07:31 AM                                         
                     
                    Please respond to                                           
                     
                    MIDRANGE-L                                                  
                     
                                                                                
                     
                                                                                
                     




Hi everyone,
I have a strange problem here with CA that hopefully someone can shed a
little light on. When a certain user tries to connect to our AS/400
(V4R3M0)
using Client Access (V3R2M0) the connection fails with the following:
"CWBLM0020 License manager software error" It is only this one profile that
has a problem, the user can sign onto the 400 (if there has been a
connection established using a different profile) but cannot initiate the
connection succesfully himself. The installation of CA is ok as I have been
able to replicate the same problem on other machines using the profile, I
beleive the problem has to lie with the profile, but where or how ?

thanks

Neil

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---