Re: SNA OVER TCP/IP

Passthru can disable due to many reasons.
Check list:
1)  WRKCFGSTS *DEV  S10A8049*  And check out the status of the device.
2)  If you have TCP/IP configured over the line also (everything here is
LAN/WAN), then try pinging something over the line to see if it is only
SNA.
3)  Try having someone at the remote site pass thru to you to see if it is
only a one way problem - happens.
4)  Try configuring a session on your PC directly to the remote site.

Sometimes what happens is that I end up varying off/on the configuration
(controller and it's devices - line is normally not a problem).  This
sometimes will stop the 0009.




                                                                                
                                         
                    Winardi                                                     
                                         
                    <Winardi@toyota.ast        To:     
"'MIDRANGE-L@midrange.com'" <MIDRANGE-L@midrange.com>             
                    ra.co.id>                  cc:                              
                                         
                    Sent by:                   Subject:     SNA OVER TCP/IP     
                                         
                    owner-midrange-l@mi                                         
                                         
                    drange.com                                                  
                                         
                                                                                
                                         
                                                                                
                                         
                    10/09/00 03:32 AM                                           
                                         
                    Please respond to                                           
                                         
                    MIDRANGE-L                                                  
                                         
                                                                                
                                         
                                                                                
                                         




Hallo

I need some help.
I already configure anynet as/400 to as/400.

when I try to STRPASTHR RMTLOCNAME(S10A8049) LCLLOCNAME(TAMNET2)
I got a message like this :

Message . . . . :   APPC failure. Failure code is X'0009000000000000'.

Cause . . . . . :   An APPC failure occurred while pass-through was using

  device S10A8049 on system AS400E. The first four digits of the failure
code
  contain the reason code.  The remaining digits contain sense data. Values

  for the first four digits of the failure code are:

    0009 -- Activate session timed out.


what should i do ?

thanks

winardi
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to
MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---



+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---