RE: Configuration of TCP/IP on AS/400

[Chris Bipes <chris.bipes@xxxxxxxxxxxxxxx>]

If the line will not vary on, you are not talking to your HUB that the AS400
is plugged in to.  Is your AS400 Ethernet line configured to match your hub.
Most older hubs are 10m 1/2 duplex, while most switches are 100m Full
duplex.    Configure the AS400 line as *auto for speed and duplex.  If that
does not work, check the cable and port on the hub.  Once you get the line
to vary on, you can work on configuring the rest.
 

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

If consistency is the hobgoblin of little minds, only geniuses work here.
Karen Herbelin - Readers Digest 3/2000

-----Original Message-----
From: cherry gong [mailto:cgong@email.com]
Sent: Monday, September 18, 2000 11:05 AM
To: MIDRANGE-L
Subject: Configuration of TCP/IP on AS/400


Hi,

I am trying to configure TCP/IP on AS/400(Modle 170, V4R4), I created the
line description and TCP/IP interface according to the manual, but after I
started TCP/IP, I found that the status of the line description is RYPPND
and the interface status is starting.

I also installed NT 4.0 on AS/400, and I can ping the other PC on it with no
problem , I can ping NT on AS/400 from the other pcs too.

Is there anybody who configured the TCP/IP on AS/400 before?  Could you give
me some helps or the information resource that I can look up?

Thanks!

Sandy
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---