Printer file offset -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

Hi All,

We are having a bit of difficulty figuring out a change to a printer file.
We print to a from on a laser.  Since the form is preprinted we have to get
very close on the target for our starting point. We have not had any luck in
using the offset.  Are we missing something, no matter what we use for
values the print comes out the same.  We do print to different type of
lasers so we believe it is something we are doing wrong and not just that a
specific printer does not support it.   The printer file is a *SCS and not
an *IPDS.

Any words of wisdom?

Thanks
Ron

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.