Re: Command To Check Current Subsystem

[Don <dr2@xxxxxxxxxxxx>]

Joe,

I would be NICE if the RTVJOBA did that, but it doesn't...(HINT HINT...:)

Don in DC

-------

On Tue, 11 Jul 2000, Joe Giusto wrote:

> Is there a CL command that I can use to determine the current subsystem that
> a job is running in?
> 
> I want to use it to change subsystems via TFRJOB in the initial signon
> program.  The problem I am having is when I do the TFRJOB my initial program
> starts again and I go into a loop.  If I could check the current subsystem,
> I can skip the TFRJOB statement on the second pass.  
> 
> I tried using *LDA but that seems to be reset as well.
> 
> Thank you,
> 
> Joe Giusto II
> Patuxent Publishing Company
> 10750 Little Patuxent Parkway
> Columbia, MD 21044
> mailto:JGiusto@patuxent.com <mailto:jgiusto@patuxent.com> 
> http://www.lifegoeson.com <http://lifegoeson.com> 
> 
> +---
> | This is the Midrange System Mailing List!
> | To submit a new message, send your mail to MIDRANGE-L@midrange.com.
> | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
> | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
> | Questions should be directed to the list owner/operator: david@midrange.com
> +---
> 

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---