How to Preventing a batch job in QSNADS from starting

[eric.ong@xxxxxxxxxxxxxxx]

I have a job name S44K3691 (the serial no. of another AS/400 in another
country) started in the QSNADS subsystem. I think it was a pass-through
configuration that was created previously. I have since deleted the line,
controller and device configurations for such pass-through.

However, after each IPL, I see this job S44K3691 started as a batch job in
QSNADS.
In addition, this job was never started in the startup program. I would
love to suppress this job permanently.

Pls advise me. Thank you.

Rgds.


_____________________________________________________________________________________________________________________________________

L integrite de ce message n'etant pas assuree sur Internet, les societes du 
groupe BNP Paribas ne peuvent etre tenues responsables de son contenu.
Si vous n'etes pas destinataire de ce message, merci de le detruire et 
d'avertir l'expediteur.
                
----------------------------------------------------------------------------------
The integrity of this message cannot be guaranteed on the Internet, companies 
of the BNP Paribas group can not therefore be considered responsible for the 
contents.
If you are not the intended recipient of this message, then please delete it 
and notify the sender.
_____________________________________________________________________________________________________________________________________
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---