RE: Routing a telnet device to a subsystem

[Chris Bipes <ChrisB@xxxxxxxxxxxxxxx>]

I can help by user at signon or by "Named Device".  Try using named devices
on the clients instead of qpadevxxxx.  Say 10.10.10.128 = TN10.128.a where
all TN10's and in subsystem A.  Use a generic name in the device entry as
TN10*.  This could me a management nightmare, especially if you use dhcp to
assign IP's.

Good Luck,

Christopher K. Bipes    mailto:ChrisB@Cross-Check.com
Sr. Programmer/Analyst  mailto:Chris_Bipes@Yahoo.com
CrossCheck, Inc.        http://www.cross-check.com
6119 State Farm Drive   Phone: 707 586-0551 x 1102
Rohnert Park CA  94928  Fax: 707 586-1884

*Note to Recruiters
I nor anyone that I know of is interested in any new and/or exciting
positions. Please do not contact me.


-----Original Message-----
From: York, Albert [mailto:albert.york@nissan-usa.com]
Sent: Friday, September 17, 1999 8:57 AM
To: 'MIDRANGE-L@midrange.com'
Subject: Routing a telnet device to a subsystem


Does anybody know a way to route a telnet device to a particular subsystem
based on the IP address? 
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator:
david@midrange.com
+---
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---