RE: Table Saws and As/400 shake.... -- MIDRANGE-L

× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.

Joel,

I'm glad to see a fellow former heat treater.  Your right some of the
furnace and draw systems were very complicated to run.  I was in a heat
treat in Wisconsin were they tried to get a PC to run the system, but it
would not work.  Way too hot for the computers.  (Of course the humans were
ok in the 100+ degree heat.

Oh well, those furnaces were fun, especially when a nitrite batch was going
through and a little too much air got in the furnace.  Fabulous explosions.

Jim Oberholtzer


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---

This mailing list archive is Copyright 1997-2025 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.