Re: Moving files between multiple AS/400s using a mouse

Perhaps some work with the WRKRDBDIRE command might be necessary?




jteff19@idt.net on 04/15/99 05:26:13 PM
Please respond to MIDRANGE-L@midrange.com@Internet
To:     MIDRANGE-L@midrange.com@Internet
cc:      

Subject:        Re: Moving files between multiple AS/400s using a mouse

>QED.  Just perform the following on the 400:
>MD '/QFileSvr.400/remote400name'
>where remote400name is the name of the other 400.

The command MD 'QFileSvr.400/S10A11AA' was entered. I
didn't see it done, but I was told it worked ok.

In Operations Navigator, I click on the local system (the one
here in Minneapolis that I'm attached to with Ethernet and
TCP/IP). It asks for my UserID and Password. It then shows
me the tree and I pick File Servers. I choose QFileSvr and it
shows me S10A11AA. When I click on that, it takes a few
minutes and I get a message "An error occurred while
retreiving directories and files. Please check your communications
path to the AS/400". The remote AS/400 is located in the
Quad Cities (IA). It is connected via a 56k phone line using
SNADS. That will be changed to a T1 line using TCP/IP in a
few months. Will this work with our setup? The local AS/400
is at V4R2 and the remote is at V4R3. Both will be updated
to V4R4 later in the year.

Thanks. Joe Teff

+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---


+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---