Roger,

To recreate the ECS configuration, (i.e., line, controller, device), just CALL QTIINSTL

This creates any components of the ECS configuration that is missing.  In your case, it will create an QESPAP device.  If you were missing the line or controller, it would create these as well.

Neil

At 12:49 PM 1/4/99 -0600, you wrote:
Help! I fat-fingered away the QESPAP device description and now can't connect to ECS. The Local Device Config manual implies the description has been put there by a higher power and provides no instructions for replacing it! Anyone know where to steer me?
 
Thanks,
rp


Neil Clark
Barsa Consulting, LLC
Tel: (914) 251-9400  Fax: (914) 251-9406
http://www.barsaconsulting.com +--- | This is the Midrange System Mailing List! | To submit a new message, send your mail to MIDRANGE-L@midrange.com. | To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com. | To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com. | Questions should be directed to the list owner/operator: david@midrange.com +---

This thread ...

Replies:

Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2019 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available here. If you have questions about this, please contact [javascript protected email address].