Re: Printing of Reports ethernet/TCP-IP

Use port 9100 and *HPPJLDRV and it should work fine.  Yes you can use both at 
the same time.  You
may experience some minor problems if both methods attempt to print at the same 
time since the
jetDirect can only accept one printout at a time but unless there is a large 
amount of printing the
jobs will all print before timing out.

-- 
Larry Bolhuis         |
Arbor Solutions, Inc  | Two rules to success in life:
(616) 451-2500        | 1. Never tell people everything you know.
lbolhui@ibm.net       |

Glenn Ericson wrote:
> 
> What are the  command parameters for CRTDEVPRT if you
>   have a local TCP-IP  Ethernet 10/00 with an HP III printer thru
>  a Jet Direct  card?
> 
> Can you also [concurrently] have both the CRTDEVPRT &  the
>  OUTQ method with the IP address & Autostart writer without problems?
> 
> ----------------------------------------------------------------
> At 03:20 PM 12/8/98 -0600, you wrote:
> >
> >     It depends on how you have the two machines networked. APPN or
> >     TCPIP will work. Check out STRRMTWTR and CRTOUTQ commands. The
> >     command parms needed will depend on the connection type.
> >
> >     eric.delong@pmsi-services.com
> >
> >
> >______________________________ Reply Separator
> _________________________________
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---