RE: Time out on DDM data area

[Tim McCarthy <twmac@xxxxxxxxxxxxxx>]

Strange. What does your line description look like. If you're having
problems with the ACQ then I presume you've got a non-switched line defined
- it sounds like the line's not in an active state when the ACQ is
performed. Are you performing a vary on with no-wait or have you a long
enough vary-on wait time for all the objects? What's the flow control
setting? Do you know from the SYSOPR messages whether any recovery action
was taken - I've seen this happen before where a device does into recovery
and the connection between the line controller and device appears to be
"broken", the drastic solution in these cases is to use ENDxxxRCY to force
immediate and noticable errors.  
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to MIDRANGE-L@midrange.com.
| To subscribe to this list send email to MIDRANGE-L-SUB@midrange.com.
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---