Re: Connecting Model 200 to LAN

[Carl Galgano <cgalgano@xxxxxxxxxxxxxxxxx>]

Don:
Depends on what you want to do.  The physical connection is easy.  Buy an
ethernet transciever to allow the connection of the AS400 ethernet card to
the hub (I assume its a 10baseT hub using RJ45s).  The Ethernet transciever
will run about 50-60 bucks, it has a 15 pin thick ethernet connector on one
end and 10base T jack on the other.  Use a patch cable to connect to the hub.

Do you want to do SNA or IP over the connection?  At least you will need to
create an ethernet line, then config either ip or SNA.
Carl

At 10:33 AM 1/4/98 -0500, you wrote:
>A client has a Model 200 and will be installing an Ethernet card.
>
>What's involved in connecting this system to a hub and an NT LAN?
>
>-- Don
>
>+---
>| This is the Midrange System Mailing List!
>| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
>| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
>| Questions should be directed to the list owner/operator: david@midrange.com
>+---
>
Carl J. Galgano
http://cgalgano.home.mindspring.com
mailto:cgalgano@ediconsulting.com
EDI Consulting Services, Inc.   
540 Powder Springs Street
Suite C19
Marietta, GA 30064
770-422-2995
+---
| This is the Midrange System Mailing List!
| To submit a new message, send your mail to "MIDRANGE-L@midrange.com".
| To unsubscribe from this list send email to MIDRANGE-L-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---