Re: Migrating from PCS to CA for Win95 (again)

>     You may want to give this a shot.  Instead of creating the 12-15
> install disks, you might want to create the install disks on a
> Shared Folder (not an IFS directory, because only the new clients
> can access that), but create a folder in the QDLS directory. Then
> when you make install disks, instead of writing to A:, you write to
> this new directory.  Now all you need to do is execute the "setup"
> command in the folder from each of the remote PCs.  This will be
> much slower than creating disks for each client.

Thank you for the suggestion. 
 
>   If you had clients that were on Win 3.1 of Client Access, then
>   they could point to the new IFS directories, and you would execute
>  QCA400\WIN32\INSTALL\IMAGE\SETUP.EXE 

I like this option better.

Can I upgrade these remote PCs from PCS to CA for Win 3.1 remotely? 
Is there a command to execute on the 400 that puts CA into QDLS so 
these PCS-attached PCs can get to it?

Thanks.
Tom
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* This is the Midrange System Mailing List!  To submit a new message,   *
* send your mail to "MIDRANGE-L@midrange.com".  To unsubscribe from     *
* this list send email to MAJORDOMO@midrange.com and specify            *
* 'unsubscribe MIDRANGE-L' in the body of your message.  Questions      *
* should be directed to the list owner / operator: david@midrange.com   *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *