Re: 132X27 display and F12

[Scott Klement <klemscot@xxxxxxxxxxxx>]

I haven't run across a problem with F12 not working by itself, though 
F11, F12, F23 and F24 can fail to work if your termcap/terminfo entry
is set up wrong...  Make sure that the xterm-5250 terminfo entry is
installed properly.

If that doesnt do the trick, make sure that the string being sent by F12
in /usr/local/share/tn5250/XTerm matches the terminfo/termcap entry for
F12.

If you still don't get anywhere with that, one workaround would be to
change /usr/local/share/tn5250/XTerm, so that the F12 line reads like
this:

~Shift <Key>F12: string("\033+") \n\

which will tell it to hit ESC +  when you hit the F12 key in xt5250,
circumventing the whole terminfo/termcap issue altogether.  :)

Good luck...



On Thu, 26 Oct 2000, Vaughn T Brooks wrote:

> That works great! Thanks.
> 
> Any ideas on the F12 issue?
> 
> On Thursday 26 October 2000 10:02, you wrote:
> > On Wed, 25 Oct 2000, Vaughn T Brooks wrote:
> > > version 0.16.0pre2
> > >
> > > That works. Thanks.
> > > But, now, the Xwindow title is "xt5250 - env.TERM=IBM-3477-FC"
> >
> > You need to setup your .tn5250rc file.  Here is an example:
> >
> > ====begin .tn5250rc=====
> > myas400 {
> >     host = myas400.mydomain.com
> >     env.TERM = IBM-3477-FC
> > }
> > ====end of .tn5250rc====
> >
> > You can add as many entries as you want - one for each as400 you connect
> > to.
> >

+---
| This is the LINUX5250 Mailing List!
| To submit a new message, send your mail to LINUX5250@midrange.com.
| To subscribe to this list send email to LINUX5250-SUB@midrange.com.
| To unsubscribe from this list send email to LINUX5250-UNSUB@midrange.com.
| Questions should be directed to the list owner/operator: david@midrange.com
+---