× The internal search function is temporarily non-functional. The current search engine is no longer viable and we are researching alternatives.
As a stop gap measure, we are using Google's custom search engine service.
If you know of an easy to use, open source, search engine ... please contact support@midrange.com.


  1.  Home
  2. LINUX400
  3. October 2008

Re: Cannot retain Network config with SLES 10 in LPAR

One clarification:

I went back in using *YaST* and I could see the IP address and subnet THERE... NOT with ifconfig as indicated below.

Pete Helgren wrote:

All was well. But when I bounced SLES I lost the settings I had added so I went back and added them using ifconfig at the command line again (the IP and subnet WERE there).


Thanks,

Pete


_______________________________________________
This is the Linux/400 Discussion (LINUX400) mailing list
To post a message email: LINUX400@xxxxxxxxxxxx
To subscribe, unsubscribe, or change list options,
visit: http://lists.midrange.com/mailman/listinfo/linux400
or email: LINUX400-request@xxxxxxxxxxxx
Before posting, please take a moment to review the archives
at http://archive.midrange.com/linux400.



As an Amazon Associate we earn from qualifying purchases.

This thread ...
Replies:
Follow On AppleNews
Return to Archive home page | Return to MIDRANGE.COM home page

This mailing list archive is Copyright 1997-2024 by midrange.com and David Gibbs as a compilation work. Use of the archive is restricted to research of a business or technical nature. Any other uses are prohibited. Full details are available on our policy page. If you have questions about this, please contact [javascript protected email address].

Operating expenses for this site are earned using the Amazon Associate program and Google Adsense.