Qshell not showing error messages

One of our AS/400's seems to be having a problem running Java under
qshell.  On one system if I were to type QSH CMD('java xxxx')  it would
end with a class xxx not found error and return with a Command ended
normally with exit status 1 message.  This is what I should expect since
xxxx is not a java class.  On the second system, after attempting the
same thing, nothing happens other than ending with the Command ended
normally with exit status 1 message. When we run a valid class, it does
the same thing and nothing seems to actually happen other than returning
with a status 1.
 
Any ideas?
 
Thanks,
Larry
 
________________________________________________________
        - ISLAND PACIFIC E-MAIL LEGAL DISCLAIMER -

  This email is covered by the disclaimer linked below.
          You are urged to read the disclaimer.
        <http://www.islandpacific.com/email.htm>
_________________________________________________________