RE: Password not accepted since last changed

> From: Mark Keller [SMTP:mkeller@xxxxxxxxxx]
> did you perhaps put the password into your strcode command?  I am guessing
> that could be your problem?
> 
 No, the password is not in the strcode command, simply because I don't use
STRCODE.  I'm on V5R2, which does not require it.


> From: Wills, Mike N. (TC) [mailto:MNWills@xxxxxxxxxxxxxx]
> It is in the communication daemon down by your clock in Windows
> 
        [Johnson, Duane]  I suppose it's possible that it's contained in the
communication daemon, but if so, I can't get there to change it, nor could I
have gotten there to put it there in the first place.  When I try to bring
up "Properties"  I get the busy signal (hourglass) for a few seconds then
nothing more.  It has been that way ever since I've had this computer.

        I'm pretty sure that it was either a macro that I modified or a
command line change, but I don't remember which.
>